Fuzzy Classification Based Driving Distance Estimation for Electric Vehicles

Authors

  • C Chellaswamy Department of Electronics and Communication Engineering, Lords Institute of Engineering and Technology, Hyderabad, India https://orcid.org/0000-0002-2473-6042
  • T S Geetha Department of Electronics and Communication Engineering, Sriram Engineering College, Veppampattu, Chennai, India
  • G Kannan Department of Electronics and Communication Engineering, Narayana Engineering College, Andrapradesh, India
  • A Vanathi Department of Electronics and Communication Engineering, Rajalakshmi Institute of Technology, Chennai, India

DOI:

https://doi.org/10.48048/tis.2021.32

Keywords:

Driving distance, Full electric vehicle, Fuzzy classification method, Power consumption, Travel distance estimation

Abstract

Electric vehicle technology is an essential research field for improving full-electric vehicle (FEVs) capabilities. Different subsystem parameters in the FEVs should be monitored on a regular basis. The better these subsystems are used, the better the FEVs' performance, life, and range become. Nowadays, estimation of the state of charge (SoC) of the batteries and the driving distance is the area not been standardized sufficiently. In this study, a novel fuzzy classification method (FCM) is proposed to make the exact driving distance estimation of FEVs. The proposed FCM considers the consumed power and parameters of the battery under dynamic conditions. A test location was selected for the proposed FCM and tested under 3 different test conditions, namely, no-load, half-load and full-load conditions. Also, the performance of FCM is studied under several slope conditions, and the result shows that if the battery voltage decreases then the power consumed by the vehicle is improved in the uphill travel and the battery voltage is normal and the power consumption of the vehicle is decreased in the downhill drive. Finally, the drive distance of the proposed FCM is determined.

HIGHLIGHTS

  • Fuzzy classification based driving distance estimation for full-electric vehicle is proposed
  • Parameters of battery and power consumption has been considered under dynamic condition
  • CAN communication is established between different subsystems of electric vehicle
  • Three test conditions (no-load, half load, and full load) have been considered

Downloads

Download data is not yet available.

Metrics

Metrics Loading ...

References

E Guerra. Electric vehicles, air pollution, and the motorcycle city: A stated preference survey of consumers’ willingness to adopt electric motorcycles in Solo, Indonesia. Transp. Res. D Transp. Environ. 2019; 68, 52-64.

RA Hanifah, SF Toha, NHHM Hanif and NA Kamisan. Electric motorcycle modeling for speed tracking and range travelled estimation. IEEE Access 2019; 7, 26821-9.

K Sarrafan, KM Muttaqi, D Sutanto and GE Town. A real-time range indicator for EVs using web-based environmental data and sensorless estimation of regenerative braking power. IEEE Trans. Veh. Technol. 2018; 67, 4743-56.

S Kaya, N Kilic, T Kocak and C Gungor. A battery-friendly data acquisition model for vehicular speed estimation. Comput. Electr. Eng. 2016; 50, 79-90.

J Bi, Y Wang, S Shao and Y Cheng. Residual range estimation for battery electric vehicle based on radial basis function neural network. Measurement 2018; 128, 197-203.

J Bi, Y Wang, Q Sai and C Ding. Estimating remaining driving range of battery electric vehicles based on real-world data: A case study of Beijing, China. Energy 2019; 169, 833-43.

C Chellaiah, K Thangamani, PG Subin, P Rathinakumar and P Muthukrishnan. Design of a fuel free electric vehicle. In: VV Das and Y Chaba (Eds.). Mobile communication and power engineering. Springer, Berlin, Heidelberg, 2013, p. 296.

C Chellaswamy, L Balaji and T Kaliraja. Renewable energy based automatic recharging mechanism for full electric vehicle. Eng. Sci. Technol. Int. J. 2020; 23, 555-64.

C Chellaswamy. Performance analysis of a wind duct and SOC estimation for pure electric vehicle charging. Int. J. Control Theory Appl. 2016; 9, 27-43.

N Chang, MA Faruque, Z Shao, CJ Xue, Y Chen and D Baek. Survey of low-power electric vehicles: A design automation perspective. IEEE Des. Test 2018; 35, 44-70.

R Basso, B Kulcsar, B Egardt, P Lindroth and I Sanchez-Diaz. Energy consumption estimation integrated into the electric vehicle routing problem. Transp. Res. D Transp. Environ. 2019; 69, 141-67.

HA Yavasoglu, YE Tetik and K Gokce. Implementation of machine learning based real time range estimation method without destination knowledge for BEVs. Energy 2019; 172, 1179-86.

C Pan, W Dai, L Chen, L Chen and L Wang. Driving range estimation for electric vehicles based on driving condition identification and forecast. AIP Adv. 2017; 7, 105206.

N Daina, A Sivakumar and JW Polak. Modelling electric vehicles use: A survey on the methods. Renew. Sustain. Energy Rev. 2017; 68, 447-60.

GD Nunzio and L Thibault. Energy-optimal driving range prediction for electric vehicles. In: Proceedings of the IEEE Intelligent Vehicles Symposium, Los Angeles, CA, USA. 2017, p. 1608-13.

X Qi, G Wu, K Boriboonsomsin and MJ Barth. Data-driven decomposition analysis and estimation of link-level electric vehicle energy consumption under real-world traffic conditions. Transp. Res. D Transp. Environ. 2018; 64, 36-52.

F Duran, S Ceven and R Bayir. Drive mode estimation for electric vehicles via fuzzy logic. In: Proceedings of the 22nd International Conference Electronics, Palanga, Lithuania. 2018, p. 62-7.

J Hong, S Park and N Chang. Accurate remaining range estimation for electric vehicles. In: Proceedings of the 21st Asia and South Pacific Design Automation Conference, Macao, China. 2016, p. 781-6.

V Gass, J Schmidt and E Schmid. Analysis of alternative policy instruments to promote electric vehicles in Austria. Renew. Energy 2014; 61, 96-101.

VR Tannahill, D Sutanto, KM Muttaqi and MA Masrur. A future vision for reduction of range anxiety by using an improved state of charge estimation algorithm for electric vehicle batteries implemented with low-cost microcontrollers. IET Electr. Syst. Transp. 2015; 5, 24-32.

P Boyraz and D Dogan. Intelligent traction control in electric vehicles using an acoustic approach for online estimation of road-tire friction. In: Proceedings of the IEEE Intelligent Vehicles Symposium, Gold Coast, QLD, Australia. 2013, p. 1336-43.

M Dawei, Z Yu, Z Meilan and N Risha. Intelligent fuzzy energy management research for a uniaxial parallel hybrid electric vehicle. Comput. Electr. Eng. 2017; 58, 447-64.

F Kong, L Zhang, J Zeng and Y Zhang. Automatic measurement and control system for vehicle ECU based on CAN bus. In: Proceedings of the IEEE International Conference on Automation and Logistics, Jinan, China. 2007, p. 964-8.

L Wolfhard. CAN system engineering: From theory to practical applications. Springer-Verlag London, London, 2013.

X Wang, W Yao and G Shi. A control system of electric vehicle based on CAN bus. In: Proceedings of the International Conference on Advanced Mechatronic Systems, Zhengzhou, China. 2011, p. 580-2.

E Bassi, F Benzi, L Almeida and T Nolte. Powerline communication in electric vehicles. In: Proceedings of the IEEE International Electric Machines and Drives Conference, Miami, FL, USA. 2009, p. 1749-53.

Q Huang, J Li and Y Chen. Control of electric vehicle. Intech Open, 2012.

C Chellaswamy, JJ Durgadevi and S Srinivasan. An intelligent hand gesture recognition system using fuzzy logic. In: Proceedings of the IET International Conference on Sustainable Energy and Intelligent Systems, Chennai, India. 2013, p. 326-32.

M Dawei, Z Yu, Z Meilan and N Risha. Intelligent fuzzy energy management research for a uniaxial parallel hybrid electric vehicle. Comput. Electr. Eng. 2017; 58, 447-64.

S Çeven and R Bayir. Implementation of fuzzy logic based speed control of brushless direct current motors via industrial PC. Int. J. Intell. Syst. Appl. Eng. 2016; 4, 146-52.

S Tariq, S Lee, HK Kim and SS Woo. CAN-ADF: The controller area network attack detection framework. Comput. Secur. 2020; 94, 101857.

F Kong, L Zhang, J Zeng and Y Zhang. Automatic measurement and control system for vehicle ECU based on CAN bus. In: Proceedings of the IEEE International Conference on Automation and Logistics, Jinan, China. 2007, p. 964-8.

B Luin, S Petelin and FA Mansour. Modeling the impact of road network configuration on vehicle energy consumption. Energy 2017; 137, 260-71.

X Yuan, C Zhang, G Hong, X Huang and L Li. Method for evaluating the real-world driving energy consumptions of electric vehicles. Energy 2017; 141, 1955-68.

Meteorological data, Available at: http://www.imdchennai.gov.in, accessed April 2021.

Downloads

Published

2021-11-11

How to Cite

Chellaswamy, C. ., Geetha, T. S. ., Kannan, G. ., & Vanathi, A. . (2021). Fuzzy Classification Based Driving Distance Estimation for Electric Vehicles. Trends in Sciences, 18(22), 32. https://doi.org/10.48048/tis.2021.32