Investigation of Mild Steel Corrosion in Hydrochloric Acid Solutions by Sodium carboxymethyl Cellulose and Polyethylene Glycol

Authors

  • Uchenna Itodoh Department of Polymer and Textile Engineering, Federal University of Technology, Imo State, Nigeria
  • Innocent Madufor Department of Polymer and Textile Engineering, Federal University of Technology, Imo State, Nigeria
  • Martin Obidiegwu Department of Polymer and Textile Engineering, Federal University of Technology, Imo State, Nigeria
  • Emeka Oguzie Electrochemistry and Materials Science Research Laboratory, Department of Chemistry, Federal University of Technology, Imo State, Nigeria

DOI:

https://doi.org/10.48048/tis.2022.6237

Keywords:

Mild steel, Corrosion, Adsorption, Inhibition, Isotherm, Hydrochloric acid

Abstract

Investigation of mild steel (MS) submerged into 2 M HCl solution alongside sodium carboxymethyl cellulose (SCMC) and its mixtures with polyethylene glycol (PEG) and potassium iodide (KI) respectively was investigated by weight loss measurements, potentiodynamic polarization measurements and scanning electron microscopy (SEM). SCMC was not-good-enough at low concentration of 0.5 g/L of 2 M HCl solution at 30 °C as its inhibition efficiency (IE) stood at 42.73 and 40 % for 24 and 120 h immersion, respectively. However, increasing content of SCMC to 2 g/L of 2 M HCl solution at 30 °C, rose IE to 61.64 and 57.60 % at 24 and 120 h immersion, respectively. Effect of 0.5 g KI and PEG, respectively on 2 g SCMC/L of 2 M HCl solution at 30 °C for 24 h immersion improved IE to 70.91 and 83.64 %, respectively. Conversely, increasing temperature reduced IE of SCMC from 57.60 % at 30 °C to 46.30 % at 60 °C for 120 h immersion within 2 g/L of 2 M HCl solution; whereas 67.20 and 51.85 % at 30 and 60 °C as well as 69.60 and 55.56 % at 30 and 60 °C, respectively were obtained on adding 0.5 g KI as well as PEG, respectively to the 2 g/L SCMC. It was shown that SCMC-KI and SCMC-PEG mixtures show better IEs than SCMC alone, while the best IE of 83.64 % was found for SCMC-PEG mixture after 1 day of MS exposure to 2 M HCl solution. All inhibitor compounds were of mixed-type and obey Langmuir adsorption isotherm. Corrosion inhibition was afforded by physisorption of inhibitor compounds on the MS, while the good synergistic effect was owing to competitive adsorption of inhibitive combinations and thus enhanced inhibitor coverages on the MS. SEM gave visual evidence of adsorption by the compounds on MS.

HIGHLIGHTS

  • Steel corrosion is a primary concern in the oil and gas industry
  • In this study, mild steel corrosion in hydrochloric acid solution was inhibited by sodium carboxymethyl cellulose. However, enhanced inhibitive performance was afforded by the combination of sodium carboxymethyl cellulose and polyethylene glycol
  • Mechanism of inhibition action by sodium carboxymethyl cellulose and polyethylene glycol was highlighted
  • Chemical and electrochemical approach to corrosion study was utilized


GRAPHICAL ABSTRACT

Downloads

Download data is not yet available.

Metrics

Metrics Loading ...

References

Corrosionpedia. Steel corrosion, Available at: https://www.coprrosionpedia, accessed May 2021.

G Schmitt. Application of inhibitors for acid media: Report prepared for the European federation of corrosion working party on inhibitors. Br. Corrosion J. 1984; 19, 165-76.

F Bentiss, M Lagrenee, M Traisnel and JC Hornez. Corrosion inhibition of mild steel in 1 M hydrochloric acid by 2,5-bis(2-aminophenyl)-1,3,4-oxadiazole. Corrosion 1999; 55, 968-76.

M Yadav, L Gope, N Kumari and P Yadav. Corrosion inhibition performance of pyranopyrazole derivatives for mild steel in HCl solution: gravimetric, electrochemical and DFT studies. J. Mol. Liq. 2016; 216, 78-86.

A Dutta, SK Saha, P Banerjee and D Sukul. Correlating electronic structure with corrosion inhibition potentiality of some bis-benzimidazole derivatives for mild steel in hydrochloric acid: Combined experimental and theoretical studies. Corrosion Sci. 2015; 98, 541-50.

DK Singh, S Kumar, G Udayabhanu and RP John. 4(N, N-dimethylamino) benzaldehyde nicotinic hydrazone as corrosion inhibitor for mild steel in 1 M HCl solution: An experimental and theoretical study. J. Mol. Liq. 2016; 216, 738-46.

G Sığırcık, T Tüken and M Erbil. Assessment of the inhibition efficiency of 3,4-diaminobenzonitrile against the corrosion of steel. Corrosion Sci. 2016; 102, 437-45.

MM Solomon and SA Umoren. Enhanced corrosion inhibition effect of polypropylene glycol in the presence of iodide ions at mild steel/sulphuric acid interface. J. Environ. Chem. Eng. 2015; 3, 1812-26.

N Kıcır, G Tansuğ, M Erbil and T Tüken. Investigation of ammonium (2,4-dimethylphenyl)-dithiocarbamate as a new, effective corrosion inhibitor for mild steel. Corrosion Sci. 2016; 105, 88-99.

A Dutta, SK Saha, P Banerjee and D Sukul. Correlating electronic structure with corrosion inhibition potentiality of some bis-benzimidazole derivatives for mild steel in hydrochloric acid: Combined experimental and theoretical studies. Corrosion Sci. 2015; 98, 541-50.

A Popova, M Christov and A Vasilev. Mono- and dicationic benzothiazolic quaternary ammonium bromides as mild steel corrosion inhibitors. Part III: influence of the temperature on the inhibition process. Corros. Sci. 2015; 94, 70-8.

J Saranya, P Sounthari, K Parameswari and S Chitra. Acenaphtho[1,2-b] quinoxaline and acenaphtho[1,2-b] pyrazine as corrosion inhibitors for mild steel in acid medium. Measurement. 2016; 77, 175-86.

B Xu, Y Ji, X Zhang, X Jin, W Yang and Y Chen. Experimental and theoretical evaluation of N, N-Bis(2-pyridylmethyl) aniline as a novel corrosion inhibitor for mild steel in hydrochloric acid. J. Taiwan Inst. Chem. E. 2016; 59, 526-35.

P Mourya, P Singh, RB Rastogi and MM Singh. Inhibition of mild steel corrosion by 1,4,6-trimethyl-2-oxo-1,2-dihydropyridine-3-carbonitrile and synergistic effect of halide ion in 0.5 M H2SO4. Appl. Surf. Sci. 2016; 380, 141-50.

D Zhang, Y Tang, S Qi, D Dong, H Cang and G Lu. The inhibition performance of long-chain alkyl-substituted benzimidazole derivatives for corrosion of mild steel in HCl. Corros. Sci. 2016; 102, 517-22.

A Chetouani, B Hammouti and M Benkaddour. Corrosion inhibition of iron in hydrochloric acid solution by jojoba oil. Pigm. Resin Tech. 2004; 33, 26-31.

A Bouyanzer and B Hammouti. A study of anti-corrosive effects of Artemisia oil on steel. Pigm. Resin Technol. 2004; 33, 287-92.

EE Oguzie. Inhibition of acid corrosion of mild steel by Telfaria occidentalis extract. Pigm. Resin Technol. 2005; 34, 321-26.

EE Oguzie. Studies on the inhibitive effect of Occimum viridis extract on the acid corrosion of mild steel. Mater. Chem. Phys. 2006; 99, 441-6.

SA Umoren and EE Ebenso. Studies of the anti-corrosive effect of Raphia hookeri exudate gum-halide mixtures for aluminium corrosion in acidic medium. Pigm. Resin Technol. 2008; 37, 173-82.

M Abdallah. Guar gum as corrosion inhibitor for carbon steel in sulphuric acid solutions. Port. Electrochim. Acta 2004; 22, 161-75.

PC Okafor, UJ Ekpe, EE Ebenso, EM Umoren and KE Leizou. Inhibition of mild steel corrosion in acidic medium by Allium sativum extracts. Bull. Electrochem. 2005; 21, 347-52.

PC Okafor and EE Ebenso. Inhibitive action of Carica papaya extracts on the corrosion of mild steel in acidic media and their adsorption characteristics. Pigm. Resin Tech. 2007; 36, 134-40.

AAF Sabirneeza, R Geethanjali and S Subhashini. Polymeric corrosion inhibitors for iron and its alloys: A review. Chem. Eng. Comm. 2015; 202, 232-44.

E Bayol, AA Gürten, M Dursun and K Kayakirilmaz. Adsorption behaviour and inhibition corrosion effect of sodium carboxymethyl cellulose on mild steel in acidic medium. Acta Physico-Chimica Sinica 2008; 24, 2236-43.

MM Solomon, SA Umoren, II Udosoro and AP Udoh. Inhibitive and adsorption behaviour of carboxymethyl cellulose on mild steel corrosion in sulphuric acid solution. Corrosion Sci. 2010; 52, 1317-25.

R Aslam, M Mobin, J Aslam, H Lgaz and Ill-M Chung. Inhibitory effect of sodium carboxymethylcellulose and synergistic biodegradable gemini surfactants as effective inhibitors for mild steel corrosion in 1 M HCl. J. Mater. Res. Tech. 2019; 8, 4521-33.

SA Umoren, O Ogbobe, IO Igwe and EE Ebenso. Inhibition of mild steel corrosion in acidic medium using synthetic and naturally occurring polymers and synergistic halide additives. Corrosion Sci. 2008; 50, 1998-2006.

SA Abd El-Maksoud. The effect of organic compounds on the electrochemical behaviour of steel in acidic media - a review. Int. J. Electrochem. Sci. 2008; 3, 528-55.

SA Umoren and MM Solomon. Effect of halide ions on the corrosion inhibition efficiency of different organic species - a review. J. Ind. Eng. Chem. 2015; 21, 81-100.

EE Oguzie. Corrosion inhibition of aluminium in acidic and alkaline media by Sansevieria trifaciata extract. Corrosion Sci. 2007; 49, 1527-39.

JOM Bockris D Drazi, A Despic. The electrode kinetics of the deposition and dissolution of iron. Electrochim. Acta 1961; 4, 325-61.

A Singh, AK Singh and MA Quraishi. Dapsone: A novel corrosion inhibitor for mild steel in acid media. Open Electrochem. J. 2010; 2, 43-51.

SAM Refaey, F Taha and AMA El-Malak. Inhibition of stainless-steel pitting corrosion in acidic medium by 2-mercaptobenzoxazole. Appl. Surf. Sci. 2004; 236, 175-85.

IB Obot, NO Obi-Egbedi and SA Umoren. Antifungal drugs as corrosion inhibitors for aluminium in 0.1 M HCl. Corrosion Sci. 2009; 51, 1868-75.

EE Oguzie. Inhibition of acid corrosion of mild steel by Telfaria occidentalis extract. Pigm. Resin Technol. 2005; 34, 321-26.

A Bouyanzer, B Hammouti and L Majidi. Pennyroyal oil from Mentha pulegium as corrosion inhibitor for steel in 1 M HCl. Mater. Lett. 2006; 60, 2840-3.

AY El-Etre. Inhibition of aluminum corrosion using opuntia extract. Corrosion Sci. 2003; 45, 2485-95.

K Aramaki and N Hackermann. Inhibition mechanism of medium-sized polymethyleneimine. J. Electrochem. Soc. 1969; 116, 568-74.

W Li, Q He, S Zhang, B Pei and B Hou. Some new triazole derivatives as inhibitors for mild steel corrosion in acid medium. J. Appl. Electrochem. 2008; 38, 289-95.

Downloads

Published

2022-10-11

How to Cite

Itodoh, U. ., Madufor, I. ., Obidiegwu, M. ., & Oguzie, E. . (2022). Investigation of Mild Steel Corrosion in Hydrochloric Acid Solutions by Sodium carboxymethyl Cellulose and Polyethylene Glycol. Trends in Sciences, 19(20), 6237. https://doi.org/10.48048/tis.2022.6237